
HOW TO INSTALL
Ready to slap those decals on? We’ve got you covered. From prep to finish, we’ll walk you through cleaning, aligning, and making sure your decals stick for the long haul.

OUR ADHESIVE IS STRONG, HIGH-QUALITY, AND STICKS LIKE A BEAST
Installing our graphics can be tricky – even for the pros. No air release channels here (25% more adhesive). Our vinyl’s polymeric, non-stretchable (so it’s nothing like that flimsy car wrap stuff). Keep the stretching and heatgun to a minimum – trust us, it’ll make your life easier. Once you’re done, hit all edges and pieces with a little heat, and stay chill, because when you follow these steps it’s going to turn out flawless.
LET'S GET STARTED
-
TOOLS NEEDED
- Heat gun
- Clean cloth (microfiber is best)
- Detergent
- Plastic scraper (included)
-
TIPS
Watch out around air vent meshes as they’re prone to melting. Either be careful with the heat gun or just remove them completely. If you see any bubbles, grab a needle and poke a hole in the bottom and side of the bubble. Then use the heat gun and gently press towards the hole with your thumb. For the best bond, let it sit for 24 hours and check the edges again before you take it out for a ride.
-
Step 1
PREPARATION
First, get rid of any old stickers. Heat them up with the heat gun, peel back an edge, and yank 'em off. Don’t let the old contours mess with your new look. Clean your ride like it’s your baby – get rid of grease with a solid detergent (surface cleaner). Old glue? Hit it with some label-off spray. Now, double-check where every piece goes – it’s pretty damn obvious once you start looking.
-
Step 2
INSTALLATION
Mix some dish soap with water in a spray gun, and spray a bit on both the back of your decal and the area where it’s going. This makes sliding the pieces around easy so you can get them exactly where they belong. Be warned – once that strong adhesive touches down, it’s locked in for good. Place the decal lightly to check the fit. When it’s perfect, grab the scraper (the soft side, obviously) and work from the center out to push all the air and water out. Once that’s done, it’s permanent. And no, it won’t come off without a fight.
-
Step 3
POST INSTALLATION
Now it’s time to make it really permanent. Heat each piece with the heat gun – get it hot enough so your hand’s a bit uncomfortable when you hover over the decal (10-15 cm distance). Apply pressure while you heat it, push and stroke with your other hand to make sure it sticks for the long haul.
-
Step 4
FINISHING TOUCHES
Once everything’s stuck, hit the edges with a little more heat. Warm ‘em up and press them down with your thumb, working your way around all the edges to make sure they’re sealed tight.
VIDEO GUIDE
HAVE QUESTIONS?
Not sure about something in the guide or have follow-up questions?
Feel free to send us a message - we're here to help!